Sewer Authority Solves Tank Clogging Issues with Aeration and Mixing System
The Lackawanna River Basin Sewer Authority’s Wastewater Treatment Facility in Archbald, Pa., was facing problems with its fine bubble aeration system. An older facility built in the 1970s, the plant had implemented several upgrades over the years to improve sludge thickening, dewatering, and aerobic digestion processes.
The facility’s two equalization tanks were originally used as anaerobic digesters, which did not require aeration mixing. Over time, the tanks were converted to aerobic digesters, and retrofitted with fine bubble aeration mixing systems.
While these upgrades improved the plant’s ability to concentrate solids and reduce the volume of sludge to process, the original fine bubble aeration system experienced clogging problems, even though many of its parts had been replaced or upgraded over the years.
The facility needed to consistently improve and increase its solids concentration — from between 1 and 2 percent, up to 4 percent — in its tanks, but the fine bubble diffuser system was not designed to handle the higher sludge concentration. Fouling also occurred over time, since no backflow prevention was built into the original diffuser system design. This created the need for additional maintenance, as well as loss in performance for the process. Solids frequently built up in the tanks, causing odors due to formation of H2S. This led to more downtime, as tanks would require intermittent cleaning since solids could not be re-suspended within them.
A Simple Solution to a Complex Problem
After carefully reviewing how to solve these problems, the Lackawanna River Basin Sewer Authority made the decision to install the Tideflex® Aeration Mixing System. The Tideflex System is completely sealed, restricting surrounding wastewater and solids from infiltrating its diffusers and manifold piping. The system also provides built-in backflow prevention. Since the system can be installed within a few inches from the tank floor, it efficiently isolates wastewater while maximizing mixing and can also be operated in an on/off mode to reduce energy costs.
After only a few years, the results have been tremendous. In the sludge holding tank, solids are now operating from 0.7 percent to 1.5 percent. In the aerobic digester, solids concentration is up to 4 percent and sometimes as high as 5 percent.
“The Tideflex® Aeration and Mixing System was able to improve performance and reduce maintenance by virtually eliminating the clogging issues we had experienced in the past, along with increasing our ability to control overall plant operations and processes,” Plant Superintendent Bob Davis said.
In addition to installing the Tideflex® Aeration System, other supporting systems were upgraded, including polymer feed, dewatering equipment, and sludge pumping systems to improve sludge thickening, dewatering, and aerobic digestion processes. The overall result has been trouble-free operations and significantly reduced operating costs. WW
Red Valve Company is the largest manufacturer and supplier of pinch and check valves for municipalities and industrial plants worldwide. Learn more at www.redvalve.com.
